Item
Model
Peak hold function
Input resolution
Display resolution
Direction
Maximum response frequency
Addition and subtraction function
Alarm
Data storage
Temperature
Power consumption
*5*6
Mass
Power voltage
Compatible measuring probe
∗ 3: RS-232C (8 pin mini-DIN connector)
Reset, preset value setting/recall, peak-hold start, comparator value
setting, current value/maximum value/minimum value/peak-to-peak value
selection and output.
∗ 4: EXT.IN terminal (mini-jack)
Data output start
76
LT20-101
101B
Maximum, minimum, and peak-to-peak values. Measuring started by start input of terminals.
—
—
0.0005 mm, 0.001 mm, 0.005 mm, 0.01 mm selectable
0.0005 mm, 0.001 mm, 0.005 mm, 0.01 mm (0.00002", 0.00005", 0.0002", 0.0005") selectable
—
Speed over or probe's cable disconnected (Displayed on LCD or terminals' comparator outputs are all "H" (OFF).)
BCD alarm
—
terminal "H " (OFF)
Resolution, direction, comparator value, preset value, modes.
—
BCD sign
Operating temperature: 0 to 40°C Storage temperature: –10 to 50°C
4 W
5 W
Approx. 270 g
Approx. 300 g
101C
201
RS-232C can set
—
or start.
Can be switched
2.5 MHz (A/B phase difference)
A+B, A–B, B–A can be set with the direction setting.
See P73
—
Data signalling rate, etc.
—
4 W
6 W
Approx. 290 g
Approx. 280 g
Terminals: DC10.8 to 26.4 V.
DG, DL series
∗ 5: With measuring unit connected.
∗ 6: When the power is on, the rush current flows at approximately 1 A for
20 ms.
201B
201C
RS-232C can set
—
or start.
BCD alarm
See P73
terminal "H " (OFF)
BCD sign
Data signalling rate, etc.
8 W
6 W
Approx. 340 g
Approx. 300 g