Sony LT20 Serie Anleitung Seite 61

4. Setting the display resolution or direction
(channel A)
One of 0.0005, 0.001, 0.005, 0.01,
–0.0005, –0.001, –0.005, or
–0.01 mm can be chosen.
• With the measuring probe's
spindle pushed in:
+: positive direction
–: negative direction
∗ When set to inches, values are chosen from 0.00002,
0.00005, 0.0002, 0.0005, –0.00002, –0.00005, –0.0002,
and –0.0005.
Note
The resolution cannot be set higher than the resolution set
in step 2.
5. Setting the display resolution or direction
(channel B, 2 channel models)
One of 0.0005, 0.001, 0.005, 0.01, –0.0005, –0.001,
–0.005, or –0.01 mm can be chosen.
• With the measuring probe's spindle pushed in:
+: positive direction
–: negative direction
• When displaying A+B:
If you set the direction of A to "–" the data displayed is
the calculation "–A+B".
The same can be done with B.
Note
• The resolution cannot be set higher than the resolution
• When the addition A+B is chosen the direction for B can
A
6. Selecting the start input terminal (terminals) function
factory-set
Initial settings are now complete for the standard model.
Pressing
set in step 3.
be selected, but its resolution will be the same as that of A.
(See P60 "6. Terminals I/O".)
: Start function
When the peak-hold is
c h o s e n s e t t i n g t h i s
terminal to "L" (ON) sets
the peak-hold value to
the current value and
r e s t a r t s t h e s t o r i n g
procedure.
: Hold function
When using the current value measuring mode
with the start function, setting this terminal to
"L" (ON) stores the output and display of the
Go/No Go comparison at that point in time.
Note
A t t h i s t i m e , d i s p l a y a n d G o / N o G o
comparison output storage by the DRQ input
for the BCD model and EXT. IN input for the
RS-232C model is invalidated .
.. Basic model → Returns to the measuring state.
MODE
BCD model → Go to section 5-1-2.
RS-232C model → Go to section 5-1-3.
factory-set
53