Operation; Initial Settings; Basic Settings - Sony LT20 Serie Anleitung

5. Operation

This sections uses the 2 channel model in its explanations.
The 1 channel model is the same as the 2 channel model
without the B channel.
BCD and RS-232C models are noted in the text.

5-1. Initial settings

A standard initialization is carried out at the time of
shipping, however it is possible to make the following
selections depending on intended use. Details of the
settings at the time of shipping are given in each section.
• Changing between inches/mm
Turn on power while holding down
Press to change between inches/mm.
Press to set and return to the measuring state.
SET
• Device is set to mm at the time of shipping.
• To change the initial settings hold down the
press the key for approximately 2 seconds.
MODE
Basic operation
: to the next item.
MODE
: Select item.
: Set item.
SET
Note
• Even if you select an item with the
will be mode until you press the
• Once the initial setting mode has been entered it is not
possible to return to the measuring state partway
through. Press the
52
and press
RESET
A
SET
key, no changes
key.
SET
key repeatedly to skip the items.
MODE

5-1-1. Basic settings

1. Setting the display
(2 channel models)
One of the following may be
chosen: A and B
Only A+B
2. Setting the input signal resolution (channel A)
One of 0.0005, 0.001, 0.005, or
0.01 mm can be chosen.
• Set the resolution to match
the resolution of the
connected measuring probe.
key.
MODE
3. Setting the input signal resolution
key and
(channel B, 2 channel models)
One of 0.0005, 0.001, 0.005, or 0.01 mm
can be chosen.
• Set the resolution to match
the resolution of the connected
measuring probe.
A
B
factory-set
A
factory-set