Sony LT20 Serie Anleitung Seite 63

2. Setting the data signalling rate
is displayed and the data
signalling rate can be selected.
600, 1200, 2400, 4800, 9600,
19200 bps
3. Setting the data length
is displayed and the
data can be set to 7 or 8 bits.
4. Setting the stop-bit
is displayed and the stop
bit can be set to one or 2 bits.
5. Setting the parity
parity can be switched on or off.
Note
When the data length is set to 7 bits
in step 3, select "Parity".
factory-set
6. Selecting odd or even parity
Switches to this mode when
factory-set
7. Selecting the function for the EXT.IN terminal
factory-set
is displayed and the
: No parity
: Parity
is chosen above.
: Odd parity
: Even parity
: Mode for using the
PZ201 foot-switch
(sold separately).
: Mode for shortening the
output interval to less
than given above.
: To output at a set
interval.
Note
Here the EXT.IN terminal
cannot be used.
factory-set
factory-set
factory-set
55