Sony LT20 Serie Anleitung Seite 81

3. The output data format
Changing according to the initial settings (See P54.).
1 Normal condition
Initial setting :
Normal output (set at time of shipping)
1st byte
2nd byte
3rd to 9th bytes : Numerical data (ex.123.456)
Initial setting : (Outputting with measurement
mode information)
1st byte
2nd byte
3rd byte
4th byte
5th to 11th bytes : Numerical data (ex.000.000)
Initial setting :
Outputting according to the mode 1 format
(statistical calculations) of the digital printer
P40 (P40 is sold separately).
: Channel name (A or B)
: Sign (space: "+", "–")
: Channel name (A or B)
: Current mode
( N : Current value,
P : Peak-to-peak value,
I : Minimum value,
A : Maximum value)
: Unit (M: mm, I: inch)
: Sign ("+" or "–")
2 When an alarm is triggered
Initial setting :
For an overflow alarm
1st byte
2nd byte
3rd byte
4th to 9th bytes : Numerical data
For a non-overflow alarm
1st byte
2nd byte
Initial setting :
1st byte
2nd byte
3rd byte
Initial setting :
Outputting according to the mode 1 format
(statistical calculations) of the digital printer
P40 (P40 is sold separately).
Note
• For the 2 channel model, whether to output B channel
data following a space or to divide it with the delimiter is
selected by the initial setting (See P56, step 9.).
• When set to
mode even the 2 channel model only
outputs the A channel data only.
: Channel name (A or B)
: Sign (space: "+", "–")
: F
: Channel name (A or B)
: E
: Channel name (A or B)
: E
: F (For an overflow alarm)
O (For a non-overflow alarm)
73