Parts Description - Makita BL1055B Betriebsanleitung

CAUTION:
Only use genuine Makita batteries.
Use of non-genuine Makita batteries, or batteries that
have been altered, may result in the battery bursting
causing fires, personal injury and damage. It will also
void the Makita warranty for the Makita tool and charger.
Tips for maintaining maximum
battery life
1. Charge the battery cartridge before completely dis-
charged. Always stop tool operation and charge the
battery cartridge when you notice less tool power.
2. Never recharge a fully charged battery cartridge.
Overcharging shortens the battery service life.
Charge the battery cartridge with room tempera-
3.
ture at 10 °C - 40 °C (50 °F - 104 °F). Let a hot
battery cartridge cool down before charging it.
When not using the battery cartridge, remove
4.
it from the tool or the charger.
Charge the battery cartridge if you do not use
5.
it for a long period (more than six months).

PARTS DESCRIPTION

Fan unit
► Fig.1
1 Fan unit
Optional accessory
► Fig.2
1 Battery holder for CXT
battery cartridge
3 Battery BL1055B
(Country specific)
5 LXT battery cartridge
(14.4 V / 18 V max)
INSTALLATION
Charging the battery
Battery cartridges used with battery holder
Refer to the instruction manual of the charger for how to
charge the battery.
Battery BL1055B
Open the cover on the USB port. Connect the battery
and AC Power Adapter ADP07 (not included) or other
general USB charger using the USB cable supplied with
the battery. The recommended output spec for general
USB charger is 5 V / 3 A or lower. After that, plug the AC
Power Adapter ADP07 to the mains. When the charging
is finished, all battery capacity indicator will light up
and then turns off after a certain period. Unplug the AC
Power Adapter and disconnect the USB cable, and then
close the cover.
► Fig.3: 1. AC Power Adapter ADP07 2. Battery
BL1055B 3. Cover 4. USB cable
2 Power cable
2 Battery holder for LXT
battery cartridge
4 CXT battery cartridge
(10.8 V - 12 V max)
- -
Meaning of the indicator lamp
Indicator lamps
Lighted
(The lamps go off after a certain period.)
Installing or removing the battery
cartridge
Only when using the battery cartridge used with
battery holder
CAUTION:
Always switch off the device
before installing or removing the battery
cartridge.
CAUTION:
Hold the battery holder and the
battery cartridge firmly when installing or remov-
ing the battery cartridge. Failure to hold the battery
holder and the battery cartridge firmly may cause
them to slip out of your hands and result in damage
to the battery holder and battery cartridge and/or a
personal injury.
To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Insert it all the way until it locks in place
with a little click. If you can see the red indicator as
shown in the figure, it is not locked completely.
To remove the battery cartridge, slide it from the battery
holder while pressing the button on the front of the
cartridge.
► Fig.4: 1. Red indicator 2. Button 3. Battery cartridge
4. Battery holder
CAUTION:
Always install the battery car-
tridge fully until the red indicator cannot be seen.
Otherwise the battery cartridge may accidentally
fall out of the battery holder, causing injury to you or
someone around you.
CAUTION:
Do not forcibly install the battery
cartridge. If the battery cartridge does not slide in
easily, it is not being inserted correctly.
9 ENGLISH
Off Blinking
(The charging
Remaining
capacity
100%
is finished)
50% to 100%
25% to 50%
0% to 25%