Specifications; Functional Description - Makita M4000 Betriebsanleitung

ENGLISH (Original instructions)
1. Switch trigger
2. Lock button
3. Air volume adjusting dial

SPECIFICATIONS

Capacities
No load speed (min
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2014
Intended use
The tool is intended for blowing dust.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
General power tool safety
warnings
WARNING: Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
Save all warnings and
instructions for future reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
BLOWER SAFETY WARNINGS
1. Always use protective goggles, a cap and mask
when using the blower.
2. Never point the nozzle at anyone in the vicinity
when using the blower.
3. Warning - Electric shock could occur if used on
wet surfaces. Do not expose to rain. Store
indoors.
4. Never block suction inlet and/or blower outlet.
Increased motor revolution may cause dangerous
fan breakage.
Explanation of general view
4. Nozzle
5. Pin
6. Blower outlet
Model
Max. air volume
-1
)
Overall length
Net weight
Safety class
5. The blower is not intended for use by young
ENE018-1
children or infirm persons without supervision.
6. Young children should be supervised to ensure
ENF002-2
that they do not play with the blower.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product (gained
from repeated use) replace strict adherence to safety
rules for the subject product. MISUSE or failure to
follow the safety rules stated in this instruction
GEA010-2 manual may cause serious personal injury.

FUNCTIONAL DESCRIPTION

CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function on the
tool.
Switch action
CAUTION:
• Before plugging in the tool, always check to see that
the switch trigger actuates properly and returns to the
"OFF" position when released. (Fig. 1)
To start the tool, simply pull the switch trigger. Release the
switch trigger to stop.
GEB073-1
For continuous operation, pull the switch trigger and then
push in the lock button, and then release the switch
trigger.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
Air volume adjusting dial (Fig. 2)
Air speed and volume can be adjusted without positive
stops by turning the air volume adjusting dial.
To obtain high speed and increase volume, turn the air
volume adjusting dial to the A direction shown in the figure
(for the bigger number). Turn the air volume adjusting dial
7. Notch
8. Sash nozzle
M4000
3
1.2 - 2.9 m /min.
8,500 - 16,000
427 mm
1.5 kg
/II
3