Herunterladen Inhalt Inhalt Diese Seite drucken

Landing; Maintenance; Troubleshooting - XciteRC Dragon 250 Bedienungsanleitung

Race-copter
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

little less throttle.
EN

Landing:

• Carefully push the left throttle lever rearward. Try to land „smooth" without damaging the Race-Copter.
• Lock the motors: Move the right stick to the lowest right position and hold it for about 3 seconds.
• Disconnect flight battery in the model, and then turn off the transmitter.
• Remove the battery from the model and store with the correct storage voltage (approximately 11.5 V).
WARNING: remove the batteries / rechargeable batteries of the transmitter and model when not in
use – fire hazard!

Maintenance

To have fun with your model over a long period, occasional service work is required to get your model in good
condition and to minimize wear.
• Remove dirt or dust depending with compressed air or a soft brush after each use. For stubborn dirt, a
harder brush or a toothbrush can be used.
• To clean the body/fuselage no chemical cleaners such as thinners may used, as this damage the plastic
of the body/fuselage. Normally a piece of soft cloth is ok, stubborn dirt can be removed with washing-up
liquid.
• Check the tightness of all screws and tighten if necessary.
• Also check all connections, cables and power battery / rechargeable battery for damage.
WARNING: Damaged batteries or rechargeable batteries must not be used again and must be
disposed of immediately – fire hazard! Please note the disposal notes at the end of this manual.
• Check the model for worn, broken or jammed parts and gears and repair if necessary.
WARNING: remove the batteries / rechargeable batteries of the transmitter and model when not in
use – fire hazard!

Troubleshooting

Problem
Motors won't start
Model doesn't take off
The quadcopter does not react
to the transmitter
26
Landing · Maintenance · Trouble shooting
Solution
Unlock the motors, see chapter Getting started
Battery voltage low, recharge or exchange battery
Quadcopter not bound to the transmitter, see chapter Binding
Check the assembly of the propellers – rotational direction
Transmitter battery voltage low, recharge or change battery
Quadcopter not bound to the transmitter, see chapter Binding
XciteRC Dragon 250

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Inhaltsverzeichnis