Fitting And Use; Cleaning And Maintenance - Bosch TastyMoments MUZ9GM1 Gebrauchsanleitung

en

Cleaning and maintenance

Recommended speeds
M Ideally suited for all functions.
When chopping e.g. herbs, quickly
switch setting M on several times
one after the other.
1–7 Not suitable for use with this
accessory!
z
Preparation
X Image sequence C
Important: Only prepare the base unit as
described in the main operating instructions.
Remove the rear protective drive cover. The
accessory can only be operated if the bowl
is fitted properly.
1. Prepare the ingredients and add to the
required container. Do not exceed the
max mark!
2. Grasp the blade insert by the blade
guard and insert into the blade holder.
Press the blade insert down until it
audibly clicks into place.
3. Remove the blade guard.
4. Turn the blade holder over and place on
the container.
5. Rotate the blade holder in a clockwise
direction (m) as far as possible.
6. Turn the attachment over.

Fitting and use

X Image sequence D
1. Position the attachment as shown on
the rear red drive. Press down and
rotate in a clockwise direction as far as
possible.
Note: If the attachment cannot be fitted
onto the drive, check whether the blade holder
has been rotated on the jug as far as possible.
2. Plug the mains plug into the mains. Turn
the rotary switch to setting r and hold.
3. Hold the rotary switch until the required
consistency is achieved.
4. Release the rotary switch and wait for
the appliance to come to a standstill.
Disconnect the mains plug.
5. Rotate the attachment in an anticlockwise
direction and remove. Turn the
attachment over.
14
6. Rotate the blade holder in an
anticlockwise direction and remove.
7. Attach the blade guard and press until it
clicks into place.
8. Empty the container or close with the lid.
Note: When closing, observe the marking
on the lid (lnm).
■ Clean all parts directly after use.
X "Cleaning and maintenance" see
page 14
Cleaning and maintenance
The attachments and accessories used
must be thoroughly cleaned after each use.
W Risk of injury!
Whenever working with the blade insert
(assembly, disassembly, cleaning), always
attach the blade guard. Never touch the
blade with bare hands!
Caution!
– Do not use any cleaning agents
containing alcohol or spirits.
– Do not use any sharp, pointed or metal
objects.
– Do not use abrasive cloths or cleaning
agents.
– Do not wedge plastic parts in the
dishwasher as they could become
permanently deformed.
X Fig. E
1. Press the blade insert out of the centre
of the blade holder.
2. Remove the blade insert with the blade
guard.
Notes:
– When processing food such as
carrots, the plastic parts may become
discoloured, but this can be removed
with a few drops of cooking oil.
– To preclean the attachment, add a little
water and detergent and proceed as
described under "Use", switching on
briefly at setting M.
– Pour out the water and rinse the parts
with clean water.
In Fig. E you will find a summary of how to
clean the individual parts.