Water Connection - Haier XIB 6B2S3FS Bedienungsanleitung

WATER CONNECTION

The appliance must be connected to the water
mains using new hose-sets. The old hose-sets
should not be reused.
The inlet and drain hoses can be directed to
•
left or right.
The dishwasher can be connected to either
cold or hot water, as long as it is no hotter than
60°C.
Water pressure must be between 0,08 MPa
•
and 0,8 MPa.
The inlet hose must be connected to a tap so
•
that the water supply can be cut off when the
machine is not in use (fig. 1 B).
The dishwasher is fitted with 3/4" threaded
•
connector (fig. 2).
Connect inlet hose "A" to water tap "B" with a
•
3/4" attachment making sure that it has been
properly tightened.
If it is necessary, the inlet pipe can be
•
lengthened up to 2,5 m. The extension pipe is
available from the After Sales Service Centre.
If the dishwasher is connected to new pipes or
•
to pipes which have not been inuse for a long
time run water through for a few minutes
before connecting the inlet hose. In this way
no deposits of sand or rust will clog up the
water inflow filter.
1
2
B
A
EN 86