Haier XIB 6B2S3FS Bedienungsanleitung Seite 115

FAULTS
6. On electronic
appliances without a
display: one or more
indicator lights
flashing quickly
7. Dishes only partially
washed
8. Detergent not
dispensed or partially
dispensed
9. Presence of white
spots on dishes
10. Noise during wash
11. The dishes are not
completely dry
CAUSE
Water supply tap turned off
See point 5
Bottom of saucepans have not been
washed well
Edge of saucepans have not been
washed well
Spray arms are partially blocked
The dishes have not been loaded
properly
The end of the drain pipe is
immersed in water
An incorrect amount of detergent
has been measured out, or the
detergent is old and hard
The cap of the salt container is not
closed properly
The wash programme is not
thorough enough
Cutlery, dishes, pans, etc., stop the
detergent dispenser from opening
Mains water is too hard
The dishes knock against one
another
The revolving arms knock against
the dishes
Inadequate air flow
Rinse aid missing
EN 115
SOLUTION
Switch off the appliance. Turn on the
tap. Re-set the cycle.
Check
Burnt on food remains must be soaked
before putting pans in dishwasher
Reposition saucepans
Remove spray arms by unscrewing ring
nuts clockwise and wash under running
water
Do not place the dishes too close
together
The end of the drain pipe must not
come into contact with the outflow
water
Increase the measure according to how
dirty the dishes are, or change
detergent
Tighten it properly
Choose a more vigorous programme
Position dishes so as not to obstruct the
dispenser
Check salt and rinse aid level and
regulate. Should the fault persist,
contact the Technical Assistance
Centre
Re-check loading of dishes in the basket
Re-check loading of dishes in the basket
Leave the dishwasher door ajar at the
end of the wash program to allow the
dishes to dry naturally
Fill the rinse aid dispenser