"AUTOMATIC" PROGRAMMES
(only on some models)
Models with Smart Loading Sensor
The " AUTO SENSOR " programme, thanks to an
algorithm that analyses the degree of dirtiness of
the dishes in real time, automatically sets the ideal
temperature and washing time, optimising water
and electricity consumption
Models with dirt sensor
(Only on some models).
The dishwasher is equipped with a dirt sensor,
capable of analysing water murkiness during all
"AUTOMATIC"
programme
programme legend). Thanks to this device, the
wash cycle parameters are automatically
adapted to the real quantity of dirt on dishes.
This is because water murkiness is linked to the
quantity of dirt on dishes. Thus, excellent
washing results are guaranteed while optimising
water and energy consumption.
"IMPULSE" PROGRAMMES
(only on some models)
The "IMPULSE" programmes use an impulse
washing technology, which reduces consumption
and noise, and improves performance.
The "intermittent" working of the washing
pump is NOT to be considered a malfunction;
it is a characteristic of impulse washing, and
therefore should be considered a normal
feature of the programme.
ADDISH
(POSSIBILITY OF ADDING
DISHES AFTER THE PROGRAMME HAS
STARTED)
The cycle is automatically paused and the
message "DOOR OPEN" appears on the display
when a door is opened while the program is
running. Every 7 seconds or when any button is
pressed the message:
"ADD-DISH ON" appears if dishes can be
•
added and correct washing is guaranteed.
"ADD-DISH OFF" appears if dishes should not
•
be added because correct washing cannot be
guaranteed.
The cycle restarts from where it left off when the
door is closed.
Open the door slowly and carefully, to avoid
getting wet with splashes of washing water.
phases
(see
EN 104
WARNING
If you open the door during the drying cycle,
an intermittent audio signal advises you that
the drying cycle has not yet finished.
The buzzer stops after 2 minutes and the
machine turns off.
PROGRAMME INTERRUPTION
Opening the door when a programme is running is
not recommended especially during the main wash
and final hot rinse phases. However, if the door is
opened while a programme is running (for example,
to add dishes) the machine stops automatically.
Close the door, without pressing any buttons. The
cycle will start from where it left off.
WARNING
If you open the door during the drying cycle,
an intermittent audio signal advises you that
the drying cycle has not yet finished.
CHANGING A RUNNING PROGRAMME.
Proceed as follows to change or cancel a running
program:
Keep the START/RESET button pressed for at
•
least 3 seconds. "RESET" will appear on the
display and acoustic signals will be emitted.
The running programme will be cancelled.
•
At this point a new programme can be set
•
using the " PROGRAMME SELECTION" button.
WARNING
Before starting a new programme, you should
check that there is still detergent in the
dispenser. If necessary, top up the detergent.
PROGRAMME OPERATIONS
While the programme is running, the display
shows the time remaining until the end of the
cycle and the name of the programme set can
be displayed by pressing any key except for
"START/RESET"
If there is any break in the power supply while
the dishwasher is operating, a special memory
stores the selected programme and, when the
power is restored, it continues where it left off.
PROGRAMME END
A 5 second buzzer will sound (if not muted) 3
times at 30 second intervals to signal that the
programme has ended.
Only for models with the "OPEN DOOR"
option, during the drying phase the door will
open automatically and you will have to wait
until for the end-of-cycle signal before
removing the dishes.