Cleaning And Maintenance - Haier XIB 6B2S3FS Bedienungsanleitung

CLEANING AND MAINTENANCE

Looking after your appliance correctly can
extend its lifespan.
CLEANING THE APPLIANCE'S EXTERIOR
Disconnect the machine from the power
•
supply.
To clean the dishwasher outside, do not use
•
solvents (degreasing action) neither abrasives,
but only a cloth soaked with water.
CLEANING THE APPLIANCE'S INTERIOR
The dishwasher does not require special
•
maintenance, because the tank is self-
cleaning.
Regularly wipe the door gasket with a damp
•
cloth to remove any food remains or rinse aid.
Dishwasher cleaning is recommended, in
•
order to remove limestone deposits or dirt.
We suggest you run a washing cycle
periodically with specialist dishwasher cleaning
products. For all cleaning operations the
dishwasher must be empty.
If, in spite of the routine cleaning of the filters,
•
you notice that the dishes or pans are not
properly washed or rinsed, check that all the
spray heads on the rotor arms (fig. "A" - "A5")
are clear.
If they are blocked, clean them in the following
way:
1) to remove the upper rotor arm, turn it until it
lines up with the stop marked by the arrow
(fig. 1b). Push it upwards (fig. 1) and, keeping
it pushed in, unscrew it in a clockwise
direction (to reassemble it repeat the same
operation, but turn it anticlockwise). The
lower rotor arm can be removed simply by
pulling it upwards (fig. 2);
2) wash the rotor arms under a jet of water to
clear any blockage in the spray heads.
Do not use tools that can deform the
spray heads.
3) when you have finished, refit the rotor arms
in the same position, remembering to
re-align the arrow and screw into position.
(see reference figure "A" - "A5")
Both the door lining and the tank lining are in
•
stainless steel; however, should spots caused
by oxidation occur, this is probably due to a
high level of iron salts presents in the water.
The spots can be removed with a mild abrasive
•
agent; never use chlorine based materials,
steel wool, etc.
1
2
EN 100
1b