How To Fill And Empty The Tank - Abilica PocificRower Bedienungsanleitung

HOW TO FILL AND EMPTY THE TANK

1. Remove the Fill Plug (#33) from the Upper Tank Cover.
2. To fill tank with water, refer to Fig. A. Insert the Funnel (#77) into the tank, then
use a cup or the Pumping siphon (#76) and a bucket to fill the tank. Use the
water level gauge on the side of the tank to measure desired water level in the
tank.
3. To empty the tank, refer to Fig. B. Place a bucket next to the rower, and use the
Pumping siphon (#76) to pump out the water from the tank into the bucket.
4. Insert the Fill Plug (#33) into the Upper Tank Cover. Wipe excess water off of
the frame.
NOTE
:
 Fill the tank only with tap water. We strongly recommend you to purchase water-
purification tablets. Use 1 tablet in the tank each 6 months. Never use pool
chlorine or chlorine bleach. This will damage the tank and void the warranty.
WATER LEVEL
 See Fig. A. The water level gauge is on the side of the tank. The maximum fill
level is 6. Never fill it over this limit. Filling the tank over this limit will void the
warranty.
 The resistance depends on the water level in the tank. Water level 1 is the
lowest resistance. Level 6 is the highest resistance.
33
77
76
All manuals and user guides at all-guides.com
Fig.A
12
Water level label
11
33
76
Fig.B
12