Assembly/Disassembly - Vermeiren Verso Gebrauchsanweisung

EN
NL
2.4.3 Transport by vehicle, as luggage
The best way to transport your electric wheelchair in the car is to drive it by using ramps. If you
are not experienced to drive the electric wheelchair using ramps, you can put the wheelchair in
neutral mode and push the wheelchair in the car using ramps. If necessary, disassemble the
wheelchair.
1. As the wheelchair user, transfer to a car seat, see §3.5.
2. Remove all moveable parts prior to transport (footrests, arm supports, etc.).
3. Store moveable parts safely behind the passenger seat or in the luggage compartment.
4. Drive or push the electric wheelchair in the car using ramps, or lift the wheelchair in the car
with the help of 2 persons by grasping the fixed parts of the frames.
5. Attach the solid parts of the frame securely to the vehicle.
6. Place the wheelchair in drive mode (engaging the parking brakes) and check that the operating
console is switched off.
2.5

Assembly/Disassembly

CAUTION
 Make sure that your fingers, clothes, buckles won't get trapped during (dis)assembly.
Your dealer delivers the wheelchair fully assembled and explains the various operating elements
and their use. We also provide a further, detailed explanation of the different parts here for
transport purposes
To assemble the powered wheelchair:
1. Unfold the seating frame (A).
2. Place the seating frame on the front wheels and the rear support wheels.
3. Place the drive train (B) unit behind the seating frame.
4. Unscrew the star knob (1) and remove the operating console (2) from the drive train unit.
Place the console in a temporary safe place, e.g. place it over the backrest.
5. Place the hooks of the seat frame (3) on the rods (4) of the drive train unit.
6. Push the seating frame down until an audible click is heard and the frame is securely
attached to the drive train unit, both left and right. Check that the hooks (8) are locked in
downward position.
If the seat frame does not click automatically, place the frame on the drive train unit and
push the hooks (8) down manually.
7. Mount the arm supports (§3.6.2).
8. Mount the footrests (§3.6.1).
9. Slide the operating console into the support on the armrest (5). Tighten the star knob (6)
and secure the cable with the clamps (7).
To disassemble the powered wheelchair:
1. Release the cable from the clamps on the armrest. Loosen the star knob (6) on the
operating console support and slide the console out. Place the console in a temporary safe
place.
2. Pull the hooks (8) on both sides of the lower frame upwards. The drive train unit is now
released from the frame and will tilt backwards onto its support wheels.
3. Lift the seating frame up and away from the drive train unit.
4. Remove the arm supports.
5. Remove the footrests.
6. Fold the seating frame.
7. Place the operating console (2) into the designated support on the drive train unit and
tighten the star knob (1).
Risk of injuries
6
Verso
2023-06
Before use