Inhaltsverzeichnis
Werbung
2.3 Device-specific safety information
Device-specific settings are required in order to adapt the MEDICS® module to
the existing equipment. To this end, refer to the instructions in chapter "5. Com-
missioning, settings and testing", page 21ff.
Warning
2.4 General safety instructions
Bender equipment is designed and built in accordance with the state of the art and accepted
rules in respect of technical safety. However, the use of such devices may introduce risks to
the life and limb of the user or third parties and/or result in damage to Bender equipment
or other property.
Only use Bender equipment:
– as intended
– in perfect working order
– in compliance with the accident prevention regulations and guidelines applicable in the
location of use
Rectify any faults that may impair safety immediately.
Do not make any unauthorised changes and only use replacement parts and optional accesso-
ries purchased from or recommended by the manufacturer of the equipment. Failure to
observe this requirement can result in fire, electric shock and injury.
Reference plates must always be clearly legible. Replace damaged or illegible plates immedi-
ately.
Make sure that the dimensioning of the UPS (special safety power supply source), the generator
system and the whole wiring is adequate. Observe the applicable national and international
standards within this context. Only in this way, selective operation of safety devices can be
achieved and a high degree of safety in case of overload and short circuit can be ensured.
2. 1 Delivery conditions, guarantee, warranty and liability
The conditions of sale and delivery set out by Bender shall apply.
Conditions of sale and delivery can be obtained from Bender in printed and electronic for-
mat.
8
All manuals and user guides at all-guides.com
Safety instructions
TGH1322en/06.2009
Werbung
Inhaltsverzeichnis
