Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation and Operating Instructions
ATTENTION
CHAPTER 6
6 .0
INSTALLATION
6 .1
m
WARNING
6 .2
MiniVent M1/100/120 F
All of the following information and instructions are only intended for
an authorised qualified electrician!
Scope of delivery / Design
Remove the unit from the box just before installation to prevent any damage and contamination during trans-
portation and on site.
MiniVent M1/100/120.. F
ä
ù
î
ò
Preparation for wall or ceiling installation (surface mounted)
m The safety instructions in section 1 .2 must be observed!
The fan is delivered as a complete unit as standard, i.e. ready for connection. The installation and commissi-
oning of the fan should take place after the completion of all other works and after the final cleaning, in order
to prevent damage and contamination of the ventilation unit.
After the removal of packaging and the start of installation, the following points must be checked:
− is there any transport damage,
− broken or bent parts
− free movement of the impeller
Installation
The M1/100/120 F MiniVent is designed for direct wall installation. The casing must not be deformed or
warped during installation and the flatness of the installation surface must be ensured. The fans must only be
installed on sufficiently solid and stable subsurfaces with suitable fastening materials. Sufficient backflow must
be ensured! If applicable, observe instructions in DIN 1946-6.
1 . Cable exit from the wall:
− The position of the cable exit is variable in the dark area (Fig.6).
− Distance to the duct centre depending on cable exit 58/68* mm with a variable position under the casing.
− For a simple assembly an exit is recommended as shown (turnable by 90° in each case). The optimal position
is 45° each if the cable exit is directly at the position of the cable grommet.
– Duct inside diameter M1/100 F = 100 mm or M1/120 F = 120 mm and distance to room corners:
at least 90 mm, M1/120 at least 110 mm
Fig .5
ò
Facia
ù
Cover of control board
ü
including 2 x fastening screws
ä
Electronic control board
ë
Plastic casing with impeller
ö
Guide vane removable at reduced installation depth
ü
Back draught shutter removable
ö
Å
Cable grommet
î
Assembly kit
2x screws with plugs for wall mounting
Å
ë
.
7
EN
M1/100
Werbung
Inhaltsverzeichnis
