Sauber SB2 Bedienungsanleitung Seite 20

Minute setting 1.
2.
3.
During setting, press "Exit/ cancel" button to exit time setting mode.
Note: If using the time scheduling function, you shall set the time first, switch the power switch to position "I"
and connect the appliance to the charging base.
HOW TO CHARGE
1: Manual charging
When the cleaning is finished, turn off the appliance; use the adaptor to charge the appliance.
1) Plug one end of the adaptor into the charging port.
2) Plug the other end of the adaptor into the power outlet.
3) During charging, the current battery percentage will display on the panel, the "MIN" display will be off, and
the battery indicator will flash all the time.
4) When fully charged, the battery indicator will stay lit and "FF" will show on the display.
Note:
a) During charging, all keys function will be locked. They will be activated after charging.
b) If the appliance is in off state before charging, it will shut down immediately after charging;
c) If the appliance is in standby state before charging, it will switch to standby mode after charging.
2. Automatic recharging
1) Place the charging base on a plane place back against the wall.
2) Make sure no obstructions or sunken areas in the range of 1 meter on the left and right and 2 meters in
front of the charging base.
3) Connect the adaptor to the charger port of the charging base and then to the power outlet.
Note:
a) Put the power cord in order along the wall so as not to hinder device working.
b) If the launch window of infrared guidance signal on the charging base is covered or the appliance is too far
to receive the infrared signal, the automatic recharging will fail.
c) The appliance will automatically go for charging base when the cleaning is finished.
d) During cleaning, if the battery is low, the appliance will automatically go for charging base and go back to
work after charging.
e) Remember to plug in the charging base; otherwise, the appliance will keep on finding the charging base
until it runs out of battery.
When the third bar in battery indicator is flashing, minute can be set from 00 to 59;
Press "Move forward/ up" or "Move backward/ down" button to choose the right
minute;
Press "Confirm" button to confirm the setting and exit the time scheduling mode at
the same time.
- 19 -