Filling The Water Tank - Vitek VT-1203 GY Die Betriebsanweisung

CHOICE OF WATER
• To fill the water tank use regular tap wa-
ter. If the water is hard then it is recom-
mended to mix it with distilled water at a
ratio of 1:1, if the water is very hard, mix it
with distilled water at a ratio of 1:2 or use
only distilled water.
Note:
Do not fill the water tank (10) with
scented liquids, vinegar, starch solu-
tions, descaling reagents, chemical
substances etc.

FILLING THE WATER TANK

Make sure that the iron is disconnected
from electrical power before filling it with
water.
• Set the steam release regulator (3) to the
position of steam vapor OFF.
• Open the water tank lid (2).
• Fill the water tank (10) with water. Close
the lid (2).
Note:
• Do not fill it with water above MAX. in-
dication.
• If you need to refill the water tank dur-
ing ironing, turn off the iron and un-
plug the power cord from the outlet.
• When you finish ironing, open the
water tank lid (2) and pour out the re-
maining water.
IRONING TEMPERATURE
Before ironing test the heated iron on the
old cloth to be sure that the iron soleplate
(13) and the water tank (10) are clean.
• Always check the recommended iron
temperature indicated on the tag before
ironing.
• If the tag does not list the recommended
ironing temperature, but you know the
type of fabric, then use the following
table to determine the proper tempera-
ture.
VT-1203.indd 5 VT-1203.indd 5
Determination of Fabric type/tempera-
ture
Synthetics, nylon, acryl, polyester
•
(low temperature)
•• Silk/wool (medium temperature)
••• Cotton/linen (high temperature)
• This table is only for smooth materials.
Fabrics of other types (crimped, raised
etc.) are best ironed at low temperature.
• First sort items by ironing temperature:
wool with wool, cotton with cotton etc.
• The iron heats up faster than it cools
down. For this reason it is recommended
to begin ironing at low temperature (for
instance synthetic fabrics). After that,
move to higher ironing temperature.
Cotton and linen should be ironed after
all the others.
• If an item is made from a mix of fabrics,
then the iron should be set for the fabric
with the lowest ironing to (for instance if an
item is made from 60% polyester and 40%
cotton, it should be ironed at the tempera-
ture used for ironing polyester "•").
• If you cannot define the fabric the item is
made from, find a place on it that is hid-
den while wearing and, on practice select
the ironing temperature (always start at
the lowest and gradually raise it until you
get the desired result.)
• Corduroy and other fabrics that start
glossy quickly should be ironed strictly in
one direction (along the lines) with slight
pressure.
• To avoid appearance of glossy spots on
the synthetic and silk fabrics, iron them
back-side.
SETTING THE IRONING TEMPERATURE
• Place the iron on the base (8).
• Insert the power plug into the outlet.
• Set the temperature regulator (11) to the
required ironing temperature: "•", "••",
"•••" or "max" (depending on the type
of fabric), the (9) indicator will light up.
5
ENGLISH
14.08.2009 12:07:25 14.08.2009 12:07:25