Before First Use - Atag VA55312BT Benutzerinformation

Extra Dry
Activate this option when you want to
boost the drying performance. With use of
this option, the duration of some
programmes, water consumption and the
last rinse temperature can be affected.
The Extra Dry option is a permanent
option for all programmes other than Eco
50° and need not to be selected at every
cycle.
Every time Eco 50° is activated, Extra Dry
option is off and needs to be chosen
manually. In other programmes, the
setting of Extra Dry is permanent and it is
automatically used in next cycles. This
configuration can be changed at any time.
Activating Extra Dry option deactivates
Time Saver.
How to activate Extra Dry
Press . The related indicator comes on.
If the option is not applicable to the
programme, the related indicator does not
appear or it flashes quickly for a few
seconds and then goes off.
The display shows the updated
programme duration.

BEFORE FIRST USE

1. Make sure that the current level of
the water softener agrees with the
hardness of the water supply. If not,
adjust the level of the water
softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any
processing residuals that can still be
inside the appliance. Do not use
detergent and do not load the baskets.
After starting a programme, it may take up
to 5 minutes for the appliance to recharge
the resin in the water softener. It seems
that the appliance is not working. The
washing phase starts only after this
Time Saver
The Time Saver allows to reduce the time
of the selected programme.
The total programme duration decreases
by approximately 50%.
The washing results are the same as with
the normal programme duration. The
drying results can decrease.
This option increases the pressure and
the temperature of the water. The washing
and the drying phases are shorter.
By default, Time Saver is off, but it is
possible to activate it manually. This
option cannot be combined with Extra Dry
at the same time.
How to activate Time Saver
Press , the related indicator comes on.
If the option is not applicable to the
programme, the related indicator does not
come on or it flashes quickly for a few
seconds and then goes off.
The display shows the updated
programme duration.
procedure is completed. The procedure is
repeated periodically.
The salt container
CAUTION! Only use salt
specifically designed for
dishwashers.
The salt is used to recharge the resin in
the water softener and to assure good
washing results in the daily use.
How to fill the salt container
1. Turn the cap of the salt container
counterclockwise and remove it.
11