Atag VA55312BT Benutzerinformation Seite 8

8
The higher the content of these minerals,
the harder your water is. Water hardness
is measured in equivalent scales.
The water softener should be adjusted
according to the hardness of the water in
Water hardness
German de‐
grees (°dH)
47 - 50
43 - 46
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
<4
1) Factory setting.
2) Do not use salt at this level.
Whether you use a standard detergent
or multi-tabs (with or without salt), set
the proper water hardness level to keep
the salt refill indicator active.
Multi-tabs containing salt are
not effective enough to soften
hard water.
How to set the water softener
level
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
until the indicators
and flash and the display is
blank.
2. Press .
French de‐
grees (°fH)
84 - 90
76 - 83
65 - 75
51 - 64
40 - 50
33 - 39
26 - 32
19 - 25
7 - 18
<7
and
, , ,
your area. Your local water authority can
advise you on the hardness of the water in
your area. It is important to set the right
level of the water softener to assure good
washing results.
mmol/l Clarke de‐
grees
8.4 - 9.0 58 - 63
7.6 - 8.3 53 - 57
6.5 - 7.5 46 - 52
5.1 - 6.4 36 - 45
4.0 - 5.0 28 - 35
3.3 - 3.9 23 - 27
2.6 - 3.2 18 - 22
1.9 - 2.5 13 - 17
0.7 - 1.8 5 - 12
<0.7 < 5
• The indicators
and
• The indicator
• The display shows the current
setting: e.g.
3. Press repeatedly to change the
setting.
4. Press the on/off button to confirm the
setting.
The rinse aid dispenser
The rinse aid helps to dry the dishes
without streaks and stains.
The rinse aid is automatically released
during the hot rinse phase.
It is possible to set the released quantity
of rinse aid between level 1 (minimum
quantity) and level 6 (maximum quantity).
Water softener
level
10
9
8
7
6
5
4
3
2
1
,
are off.
still flashes.
= level 5.
1)
2)
,