General; Table - Pelgrim CKT755 Anleitung

maintenance
94

General

Clean the cooking appliance after each use. You can use a mild cleaning agent
for this - for example, washing-up liquid. Always clean the hobs after use. You
can use a mild cleaning agent, such as washing-up liquid, for this purpose.
Special cleaning agents for ceramic hobs have the advantage that a thin film
remains on the glass surface so that over-cooked food and lime scale are less
likely to get burnt into the hob, making it easier to clean the next time.
It is best to let the hob cool down before cleaning it. Over-cooked food
containing a lot of sugar and acids, such as apple sauce, rhubarb or red
cabbage are best removed immediately with a damp dish cloth to prevent them
getting burnt into the hob. Be careful with the hot cooking zone!
You can use a glass-scraper to remove obstinate food residue.
Traces of metals (due to sliding pans) can be difficult to remove.Special
products are available for removing traces of metal.
Never use
You should never use scouring agents. These cause scratches in which lime
deposits and dirt can accumulate.
Never use sharp objects such as steel wool and scourers.
For cleaning tips refer to the internet site 'www.hps.nl'.
faults
95

Table

If the appliance does not work properly, this does not always mean that it is
defective. Try to deal with the problem yourself first.
Phone the service department if the advice given below does not help. Only
authorised personnel may open the appliance or carry out work on the mains
power supply.
Damage caused by incorrect connection, incorrect installation or incorrect use
is not covered by the warranty.
Fault
Cooking zones do not get hot.
Error codes F00-F12 in the
display.
Error code F3 appears.
Error code F99 appears.
Spontaneous change of
setting selected.
In the case of faults visit the internet site www.hps.nl.
Cause Solution
– Appliance incorrectly – See the installation
connected. instructions for correct
– Plug not, or not completely, connection.
in the socket. – Put the plug into the socket
– Fuse(s) in the meter – Check the fuses in the meter
cupboard defective. cupboard.
– A button is defective or dirty – Clean the appliance. Do not
or there is an object on top place any objects on the
of it. Each button has its own control panel.
number, from 00 to 12. The
number associated with the
button appears in the
display.
– Transistors overheated. – Allow the appliance to cool
down until the code
disappears.
– The appliance has insufficient – Make sure there is sufficient
ventilation. ventilation.
– Two or more buttons were – Do not operate more than
operated for a long time. one button at the same time.
– Pan too close to buttons. – Make sure that pan is at least
20 mm from buttons.