Pelgrim CKT755 Anleitung Seite 45

use
88
Switching on the double-ring cooking zone (CKT755 and CKT770)
or fish pan cooking zone (CKT770)
Set the cooking zone to setting 9, press the + button.
The light under the - button will come on.
The outer cooking zone is switched on.
The outer cooking zone follows all the settings of the inner cooking zone, even
if you go to setting 0 and then select a higher setting again within 5 seconds.
You can never use the outer cooking zone on its own.
Residual-heat indicator
The indicator shows that the cooking zone is still hot, and
goes out as soon as the glass top reaches a safe
temperature. Residual heat is indicated by an H in the
display of the appropriate cooking zone..
89
Residual-heat indicator
use
Cooking timer / switch-off timer (CKT755 en CKT770)
You can have the rear right cooking zone switched off
by the cooking timer. You are then using the timer as a
switch-off timer .
1. Put a pan on the rear right cooking zone.
2. Press the on/off button.
3. Set the power level required.
4. Set the timer.
With the - and + buttons you can set a maximum cooking time of
99 minutes. If you hold the + or - button in longer, the value will increase or
decrease more rapidly. If you release the button briefly and press it again, the
value will change slowly again.
The selected number of minutes is indicated in the display.
A flashing dot indicates that the timer has been
activated. The time will now count down and the
remaining time is visible in the display.
At the end of the cooking time, you hear a beep.
The zone switches off.
Switch the beep off at the end of the cooking time by pressing the
clock's - button.
Press the clock's + button to set a new cooking time.
The other cooking zones cannot be switched off by the cooking timer. In that
case the cooking timer merely gives an audible signal at the end of the set time
(for example for use when boiling eggs).
Switch the cooking timer off by pressing the - button for a few seconds (in the
'0' minute setting).
shorter longer