Problem
Possible cause
Foam in the
Wrong detergent
dishwasher tub
Rinse aid overflow
Coloured interior of
Detergent with dye was used.
the tub
The dishes and cutlery
Unsuitable program was
are not clean
selected
Improper loading of dishes in
the baskets
Spots and film on
1. Very hard water
glasses and cutlery
2. Low temperature
3. Too many dishes in the
4. Incorrectly loaded dishes
5. Old or wet detergent
6. Empty rinse aid dispenser
7. Incorrect dosage of the
Coating on glassware.
The combination of soft water
and an excessive amount of
detergent.
Yellow or brown film
Coffee or tea spots
on interior surfaces
Metal deposits in water can
cause pervasive coating
White coating on the
Hard water containing
inner surface.
minerals
Detergent dispenser
The residue of detergent
lid does not close
clogged the lid catch.
properly
Detergent remained
The dishes blocked the
in the detergent
dispenser trays.
dispenser trays.
Steam
This is normal
Black or gray spots on
Aluminium utensils have
the dishes.
rubbed against other dishes.
Water remains on the
This is normal
bottom of the sink
Water leak from the
Overfilling dispenser or spill of
dishwasher
the rinse aid
The dishwasher is not in level
position
dishwasher
detergents
Corrective action
Use only detergents designed for automatic dishwashers. In
the case of foam, open the dishwasher door and let the foam
evaporate. Pour into the tub about 4.5 litres of cold water.
Close the dishwasher and run the program "soaking" to drain
the water. Repeat if necessary.
Wipe the spilled rinse aid immediately.
Make sure that the detergent used does not contain dyes.
Select a more intensive program.
Make sure that the effects of the detergent dispenser and
spray arms are not blocked by large dishes.
Removing spots from glass:
1. Remove all metal cutlery
2. Do not replenish detergent
3. Select the longest program
4. Run the dishwasher and let it run for about 18 to 22 minutes
before coming into the main wash.
5. Open the door and pour in 2 cups of white vinegar.
6. Close the door and let the dishwasher finish the program. If
the vinegar does not help: Repeat the above procedure, but
instead of vinegar, use 1/4 cup (60 ml) of citric acid crystals.
If you are using soft water, use less detergent for glass washing
and select a shorter program.
Use a solution of 1/2 cup of bleach and 3 cups of water and
remove stains manually.
ATTENTION!
After completing the program, wait before cleaning the
interior surface for at least 20 minutes to let the heating
elements cool down. Otherwise, there is a risk of burns.
Contact your water supplier with a request to install a special
filter.
To clean the interior, use a sponge soaked in detergent for
dishwashers. Use rubber gloves. Never use any other cleaner
than for dishwasher to prevent formation of foaming or suds.
Remove the residue of the detergent from the catch.
Rearrange the dishes.
Certain amount of steam comes through the ventilation
openings during drying and draining of water.
To remove these stains use a mild abrasive cleaner.
Small amount of water on the bottom of the sink prevents
drying of the water seal.
Make sure that you do not overfill the rinse aid dispenser.
Spilled rinse aid can cause excessive foaming and may lead to
overflow. Wipe the spilled rinse aid using wet cloth.
Make sure that the dishwasher is in level position.
23