Werbung
Verfügbare Sprachen
Verfügbare Sprachen
All manuals and user guides at all-guides.com
Attention!
The PRCD protective switch must not lay in water.
!
PRCD protective switches must not be used to switch the tool on
and off.
Before starting your work, check the proper function by
the TEST button.
Prior to putting the tool into operation, check the mains voltage for
conformity with the requirements of the tool's nameplate.
Voltage variations between + 6 % and – 10 % are permissible.
Use only extension cable with sufficient cross-section (min. 2,5 mm
cross-section which is to small could lead to excessive power loss and to
overheating the motor and the cable.
Recommended minimum cross sections and maximum cable lengths
Mains voltage
110V
230V
The tool includes a start-up speed limiter to prevent fast expulsion fuses
from unindented responding.
Additional Handle
Switching ON and OFF
Short-time operation
ON:
Press the ON/OFF switch
OFF:
Release the ON/OFF switch
Long-time operation
ON:
Keeping the ON/Off switch pressed, push in the arrestor button.
OFF:
Press and release the ON/OFF switch again.
Cross section in sq. mm
1.5
20 m
50 m
For manual drilling, the PLD 182.1 NT may be used
only together with its additional handle which comes
with the tools.
Place it on the gearing collar from the front and fix it
by turning the handle in direction of the arrow.
22
pressing
2
). A
2.5
40 m
80 m
Werbung
