Key To Individual Parameters; User Menu; Fr: Display Of Rotation Frequency; Vp: Display Of Pressure - DAB MCE-150/P Installations- Und Wartungsanleitungen

Inhaltsverzeichnis

Verfügbare Sprachen

6. KEY TO INDIVIDUAL PARAMETERS

The USER MENU is accessed by pressing MODE (or via the selection menu by pressing + or - ). Within this

menu, again by pressing MODE, the following values are displayed consecutively.

Current rotation frequency with electric pump is controlled, in [Hz].

System pressure measured in [bar] or [psi] depending on measurement system used.

Phase current of electric pump in [A]

A round flashing symbol may appear under the phase current C1symbol. This signals that the pre-alarm

threshold of maximum current allowed has been exceeded. If the symbol flashes at regular intervals it means

that the motor overcurrent protection is being activated and that it will probably be triggered. In this case it is

necessary to check the correct setting of the maximum current of the RC pump, see paragraph 6.5.1 and the

electric pump connections.

Power delivered to the electric pump in [kW].

A round flashing symbol may appear under the measured power PO symbol. This signals that the pre-alarm

threshold of maximum power allowed has been exceeded.

Displays the system status in the case of a multi-inverter installation. If there is no communication, an icon is

displayed, showing communication absent or interrupted. If there are several interconnected inverters, an

icon is shown for each. The icon bears the symbol of a pump with pump status indications below.

Depending on operating status, the item in Table 15 is displayed.

Inverter in run

Inverter in fault

System display

Symbol of pump running

Symbol of static pump

Table 17: Display of SM system monitor

Status information below icon

Frequency implemented on 3 digits