Hilti PSA Bedienungsanleitung Seite 20

Use the PSA 83 battery to power the Hilti PSA 200 tablet. Use the PUA 85 19V AC adapter to charge the
battery while it is installed in the device.
Use the PSA 85 charger to charge the PSA 82 battery.
Use the PSA 86 charger to charge the PSA 80 battery.
Use the PUA 81 AC adapter to charge the PSA 81 (01, 02 and 05) battery, the PSA 82 battery when it is in
the PSA 100 monitor (when switched off or in operating mode) and the PRA 84 battery.
Use the PUA 82 motor vehicle power adapter to charge the PSA 81 (01, 02 and 05) battery, the PSA 82
battery when it is in the PSA 100 monitor (when switched off or in operating mode) and the PRA 84 battery.
Use the PUA 85 19V AC adapter to charge the PSA 81 (05) battery and to charge the PSA 83 battery in the
PSA 200 tablet.
Use the PUA 86 19V motor vehicle power adapter to charge the PSA 81 battery (05) and to charge the
PSA 83 battery in the PSA 200 tablet.
3.3 Foreseeable faults
Do not use the PUA 85 19V to charge the PSA 81 battery (01 and 02).
Do not use the battery as a power source for other unspecified appliances.
Do not use the device where there is a risk of fire or explosion.
3.4 Battery charge status indicator PSA 81
PSA 81
The PSA 81 battery is equipped with 5 LEDs that indicate the state of charge. To display the current state
of charge, press the button on the top of the battery. Up to 4 green LEDs then light for a few seconds; the
more LEDs that light, the better is the battery's state of charge.
Status
4 LEDs light green.
3 LEDs light green.
2 LEDs light green.
1 LED lights green.
1 LED lights red.
Note
The fault may be remedied by charging the battery. If charging does not remedy the fault, the battery
must be replaced.
The error message can have the following causes:
• Voltage too high
• Short circuit
• Voltage too low
• Temperature is outside the charging temperature range
• Wrong charger is connected
• Electronic fault
While charging, the LEDs show the following statuses:
Status
3 LEDs light, 1 LED blinks.
2 LEDs light, 1 LED blinks.
1 LED lights, 1 LED blinks.
1 LED blinks.
Note
The PSA 81 (01 and 02) battery may be charged only with the PUA 81 AC adapter.
The PSA 81 (05) battery can be charged using the PUA 81 or PUA 85 19V AC adapter.
14 English
Meaning
• State of charge: 75 % to 100 %
• State of charge: 50 % to 75 %
• State of charge: 25 % to 50 %
• Charge status: < 25 %
• Error
Meaning
• State of charge: 75 % to 100 %
• State of charge: 50 % to 75 %
• State of charge: 25 % to 50 %
• Charge status: < 25 %