Küppersbusch IKE 318-8 Gebrauchs- Und Montageanleitung Seite 21

Apply covers (C-D) on joint cover lugs and into hinge
holes.
Snap vent grille (B) and hinge covers (E) into
position.
C
D
E
E
B
Separate parts Ha, Hb, Hc, Hd as shown in the
figure.
Ha
Hb
Hc
Hd
PR266
Place guide (Ha) on the inside part of the furniture
ca. 50 mm
door, as shown in the figure and mark the position of
external holes. After having drilled holes, fix the
90°
guide with the screws supplied.
ca. 50 mm
Fix cover (Hc) on guide (Ha) until it clips into place
Ha
Hc
PR33
Open the appliance door and the furniture door at
8mm
90°. Insert the small square (Hb) into guide (Ha).
Put together the appliance door and the furniture
door and mark the holes as indicated in the figure.
Remove the squares and drill holes with ø 2 mm at 8
mm from the outer edge of the door. Place the small
square on the guide again and fix it with the screws
Ha
supplied.
Hb
PR167
21