Werbung
Verfügbare Sprachen
Verfügbare Sprachen
MODULE ASSEMBLY
b
"click"
LED displays operating conditions
REMOVE BLIND CAP
• Place a screw driver at marked positions
• Break the interlock between register and blind cap by twisting
a
the screw driver.
• The type plate will break at the perforation line.
• Lever off the blind cap
• Before mounting the wMIU
target
b
ATTENTION:
The use of these meters and wMIU
moisture (such as showers or water meter pits) should be avoided, as moisture
can diffuse through the plastic cover in the long run and affect the ability to read
as well as the opto-electronic scanning. Install water meters in a frost-proof way!
c
MOUNTING THE MODULE
• Match the wMIU
e
of the register.
d
c
• Press the wMIU
gap is closed and the wMIU
• To prevent manipulation place the adhesive seal
wMIU
a
SLIDING ON ROSETTE
• After assembling the wMIU
LED LIGHTING FUNCTION
The wMIU
Installation / de-installation:
• Lights up for 15 seconds after mounting the wMIU
(water meter has been detected)
• 10 seconds after uninstalling the wMIU
(quick flashes) – removal alarm is set in wMIU
Registration in the radio system:
• Flashes once every 2 seconds after recognition from the EquaScan Fnet until
the next data set transfer (max. 5 min)
• Flashes twice every 2 seconds after switching over to the walk-by mode until
the next data set transfer (max. 5 min)
from the register.
b
V2, please check if the cover of the rotating
RF
is clean and free of scratches.
c
V2 with a flush distance of approx. 3 mm on top
RF
a
V2 against the upper part of the register
RF
RF
V2
and register
c
at the right side of the meter.
RF
e
V2, slide on the rosette and cylinder.
RF
V2 has a red LED to display the following operating conditions.
RF
a
.
V2 in areas with frequent and high levels of
RF
V2 is aligned to the register with a click.
at the junction between
d
V2 on the meter
RF
V2 the LED flashes for 15 seconds
RF
V2
RF
and push till the
b
Werbung
