Citrus Juicer - Kenwood KHC29.W0SI Bedienungsanleitungen

2 Put the food into the feed tube.
3 Switch on and push down evenly
with the pusher - never put your
fingers in the feed tube.
To use the small feed tube - put the
large pusher inside the feed tube first.
To use the large feed tube - use both
pushers together.
Do not let the bowl fill up as far as
the cutting disc: empty it regularly.
Do not exceed the 'MAX' capacity
level on the bowl.
Hints and Tips
When using the reversible discs
ensure that the required cutting side
is uppermost.
Use fresh ingredients.
Do not cut food up too small. To
stop food slipping over during
processing fill the width of the large
feed tube or use the small feed tube.
When slicing or grating: food placed
upright comes out shorter than food
placed horizontally.
After use there will always be a
small amount of waste on the disc
or in with the food.

Citrus Juicer

18
a
Cone
b
Sieve
Note: This attachment can only be used
in conjunction with the food processor
AT284.
Assemble the Citrus Juicer as shown in
18
illustration
1 Fit the sieve into the bowl ensuring
that the tab on the rim locks into the
bowl handle.
2 Fit the cone over the drive shaft
turning until it drops all the way down.
3 Cut the fruit in half. Switch to
speed 3 and press the fruit onto the
cone.
Hints and Tips
For best results store and juice the
fruit at room temperature and hand
roll on a worktop before juicing.
To help with juice extraction move
the fruit from side to side when
juicing.
When juicing large quantities,
empty the sieve regularly to
prevent the build up of pulp and
seeds.
Food Mincer
19
a
Ring nut
b
Screens: medium or coarse
(depends on model variant)
c
Cutter
d
Scroll
e
Body
f
Tray
g
Pusher
Assemble the Food Mincer as shown in
19
illustration
1 Fit the scroll inside the body.
2 Fit the cutter – ensure it is located
correctly with the cutting side
outermost.
3 Fit a screen – align the pin with the
notch.
4 Loosely fit the ring nut.
To use the Food Mincer
1 Raise the mixer head. Ensure both
outlet covers are fitted.
2 With the attachment in the position
shown - align the drive tabs on
the end of the scroll with the
corresponding slots in the drive
outlet.
3 Push the attachment into the outlet
and turn clockwise until it locks into
place.
4 Tighten the ring nut manually.
5 Fit the tray
6 Cut meat into 2.5cm (1") -wide strips.
7 Select Max speed. Using the pusher
gently push the food through, one
piece at a time. Do not push hard -
you could damage your machine.
10