HPA-Faip M 424 Betriebs- Und Wartungsanleitung Seite 55

ing/demounting vertical slide moving
slightly up and away from the edge of the
rim (fig.16a).
This space between the rim and the verti-
cal slide will be maintained for as long as
the knob is in the locking position.
The operator can tilt the tower freely (eg.
when demounting wheels of the same size)
without repositioning the vertical slide.
- Insert and position the bead lifting tool
on the mounting vertical slide (fig.17).
M 424 - M 424 FS
When working with alloy wheels or wheels
with delicate paintwork, you are advised
to remove the bead lifting tool before
proceeding with the demounting.
Grip the bead lifting tool firmly during use.
- Raise the upper bead to above the rear part
of the demounting vertical slide (fig.17a)
and force part of the upper bead into the
rim groove by pushing down on the side
wall of the tyre nearest to the operator.
16A
- Press the pedal to turn the table top clock-
wise. The upper bead will automatically
be guided up and over the rim (fig.18).
Repeat the last three points to detach the
lower bead.
- Tilt the tower backwards.
NOTE: If the tyre has an inner tube, after
detaching the upper bead, tilt the tower
back and remove the inner tube before
proceeding to demount the lower bead.
The rotation of the table top can be stopped
at any time by releasing the pedal.
To rotate in the opposite direction, simply
17
raise up the pedal.
WARNING
17A
55