HPA-Faip M 424 Betriebs- Und Wartungsanleitung Seite 52

operation, you are advised to keep the
table top closed (locking clamp towards
center) (A fig.11).
- Press the pedal 10 (fig.11) to operate the
bead breaker and detach the bead from
the rim.
Repeat this operation on the other side
of the wheel.
It may be necessary to break the bead at
several points to free it completely.
After detaching the beads, remove the old
balancing weights.
- Thoroughly lubricate the sides of the
tyre around the entire circumference of
the lower and upper bead to facilitate
the demounting and avoid damaging the
beads (fig.12).
52
- Tilt the tower backwards by holding the
knob in the "locked" position (Fig. 13).
- Set the clamps to the open or closed posi-
tion (fig.14).
12
10
M 424 - M 424 FS
A
B
11
13