Inhaltsverzeichnis
Werbung
Watch mode
STE - Squelch Tail
35
Elimination
RP-STE-Squelch Tail
36
Elimination
RPT-RL - Delay the
37
squelch tail of
repeater
PONMSG-Power On
38
Message
39
ROGER - Roger Beep
RESET – Restore
40
defaults
R-TONE-
41
Repeater Tone
B band transmit (Bottom row frequency)
*When enabled, priority is returned to selected display once the
signal in the other display disappears.
ON
OFF
*This function is used eliminate squelch tail noise between
MENU+35
Radioddity handhelds that are communicating directly (no repeater
). Reception of a 55 Hz or 134.4 Hz tone burst mutes the audio long
enough to prevent hearing any squelch tail noise.
OFF/ 1,2,3...10
MENU+36
*This function is used eliminate squelch tail noise when
communicating through a repeater.
OFF/ 1,2,3...10
MENU+37
*Delay the Tail Tone of Repeater (X100 milliseconds)
FULL: Performs an LCD screen test at power-on
MSG: Displays a 2-line power on message
MENU+38
*Controls the behavior of the display when the transceiver is turned
on.
OFF
ON
MENU+39
*Sends an end-of-transmission tone to indicate to other stations that
the transmission has ended.
VFO: Menu initialization
MENU+40
ALL: Menu and channel initialization
*Resets the radio to factory defaults, with some exceptions.
The R-TONE frequency is transmitted by Pressing the [F] side key while
the [PTT] key is also pressed.
MENU+41
A common tone burst frequency used by many amateur radio systems in
Europe is 1750Hz
29
Werbung
Inhaltsverzeichnis
