Dcs Scanning - Radioddity GT-82 Bedienungsanleitung

3. Press the [*SCAN] to begin DCS scanning
A flashing "DCS" will be in the le� status display to indicate the radio is in DCS scanning mode. In this mode, whenever the
radio is receiving an RF signal on the selected MR channel or VFO frequency, the lower display will cycle through the DCS
codes as they are being tested. Once the bits of the received DCS code are determined, the "DCS" indicator will stop
flashing.
Press the [MENU] key to save the scanned tone into memory (VFO Mode Only) then press the [EXIT/AB] key to exit the
menu.
Don't forget to set VFO menu 10 back to OFF when the DCS tone is no longer required.
6.4 Dual Watch
The Radioddity GT-82 features Dual Watch func�onality (single receiver) with the ability to lock the transmit
frequency to one of the two channels it monitors.
• Enabling or disabling Dual Watch mode
1. Press the [MENU] [7] to get to MENU 7: TDR.
2. Press [MENU] key to select.
3. Use the ▲and ▼ keys to enable or disable.
4. Press the [MENU] key to confirm.
5. Press the [EXIT/AB] key to exit the menu.
Due to the way the Radioddity GT-82 is constructed , whenever one of the A or B Frequencies (VFO/MR) goes ac�ve, it will
default to transmit on that channel. This behavior can be inconvenient, especially if when monitoring a frequency, you should
not transmit on. There is a menu op�on available to lock the transmi�er to one of the A or B channels.
• Locking the Dual Watch transmit channel
1. Press the [MENU] [3][4] to get to MENU 34: TDR-AB.
2. Press [MENU] key to select.
3. Use the ▲and ▼ keys to select A (upper) or B (lower) display.
4. Press the [MENU] key to confirm.
16