Making A Call; Channel Selec�On; Frequency (Vfo) Mode - Radioddity GT-82 Bedienungsanleitung

Inhaltsverzeichnis

counter-clock-wise. Be careful not to turn it too far, as you may inadvertently turn your radio oﬀ.

5.3 Making a call

NOTE: Press the [EXIT/AB] key to switch the main channel to the other channel if there is 2 channels shown on the display.

Turn oﬀ the radio and press and hold the [MENU] key to turn on the radio to switch between VFO and channel mode display.

• Channel mode call: A�er selec�ng a channel, hold down the [PTT] key to ini�ate a call to the current channel. Speak into

the microphone with normal tone. Ini�ate a call, the red LED is on.

• Frequency mode call: Turn oﬀ the radio and press and hold the [MENU] key to turn on the radio to switch to frequency

mode, the frequency range allowed entering, press the [PTT] key, a call to the current channel. Speak into the microphone

with normal tone. Ini�ate a call, the red LED is on.

• Receive a call: When you release the [PTT] key, you can answer it without any ac�on.

When receiving a call, the green LED is on.

NOTE: To ensure the best reception volume, keep the distance between the microphone and the mouth at the time of

transmission from 2.5 cm to 5 cm.

5.4 Channel selection

There are two modes of opera�on: Frequency (VFO) mode, and Channel or Memory (MR) mode.

For everyday use, Channel (MR) mode is going to be a whole lot more prac�cal than Frequency (VFO) mode. However,

Frequency (VFO) mode is very handy for experimenta�on out in the ﬁeld. Frequency (VFO) mode is also used for

programming channels into memory.

In Channel (MR) mode you can navigate up and down the channel by using the ▲ and ▼ keys.

Ul�mately which mode you end up using will depend en�rely on your use case.

In Frequency (VFO) mode you can navigate up and down the band by using the ▲ and ▼ keys. Each press will increment or

decrement your frequency according to the frequency step you've set your transceiver to.

You can also input frequencies directly on your numeric keypad with kilohertz accuracy.

The following example assumes the use of a 12.5 kHz frequency step.

Example. Entering the frequency 432.6125 MHz on display A

a. Turn oﬀ the radio and press and hold the [MENU] key to turn on the radio to switch to frequency mode,

Inhaltsverzeichnis