Inhaltsverzeichnis
Werbung
b. You can change the scanning direc�on with the ▲and ▼ keys.
c. Press any key to stop scanning.
Note: for Scan mode, see Menu No.18.
6.3 Tone Scanning
Scanning for CTCSS and DCS Tones/Codes
Scanning for a CTCSS tone or DCS code can be done while Frequency Mode (VFO) or Channel Mode (MR) is selected. Only
when VFO mode is selected, can the detected tone/code be saved to menu 11/10.
CTCSS tone and DCS code scanning mode can be accessed with or without a signal being present. The scanning process itself
only occurs while a signal is being received.
Not all repeaters requiring a CTCSS tone or DCS code for access will transmit one back. In that case, the transmitter of a
station that can access the repeater would need to be scanned. In other words: this would be done by listening to stations on
the repeater's input frequency.
• Scanning for CTCSS Tone
1. Press the [MENU] [1] [1] to come to Menu 11: R-CTCS
2. Press the [MENU] key to select. Insure you have a tone ac�vated (and it is not off)
3. Press the [*SCAN] to begin CTCSS scanning
A flashing "CT" will be in the le� status display to indicate the radio is in CTCSS scanning mode. In this mode, whenever the
radio is receiving an RF signal on the selected MR channel or VFO frequency, the lower display will cycle through the CTCSS
tones as they are being tested. Once the frequency of the received CTCSS tone is determined, the "CT" indicator will stop
flashing.
Press the [MENU] key to save the scanned tone into memory (VFO Mode Only) then press the [EXIT/AB] key to exit the
menu.
Don't forget to set VFO menu 11 back to OFF when the CTCSS tone is no longer required.
• Scanning for a DCS tone
1. Press the [MENU] [1] [0] to come to Menu 10: R-DCS
2. Press the [MENU] key to select. Insure you have a tone ac�vated (and it is not off)
15
Werbung
Inhaltsverzeichnis
