Dmx Operation - EuroLite LED CBB-2 Bedienungsanleitung

Notes:
• The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery
contacts prevents the battery from being discharged during storage. Prior to the first operation remove the
foil from the battery support on the rear side of the remote control. Otherwise operation of the remote
control is not possible.
• If the range of the remote control decreases, replace the battery. For this purpose,
on the rear side of the remote control press the small bar with the groove to the
right and at the same time remove the battery support. For operation, one 3 V
button cell type CR 2025 is required. When inserting, pay attention that the
positive pole of the button cell shows upwards in the support.
• Remove the battery from the remote control as a precaution if the device is not used for a longer period of
time.

DMX operation

Setting the number of DMX channels and the DMX starting address
For operation with a controller with DMX512 protocol, the device is equipped with 6 control channels.
However, it can also be switched to a mode with 2, 3 or 4 channels if different functions are required. To be
able to operate the device with a DMX controller, the DMX starting address must be set. The starting
address depends upon which DMX controller is being used. Please refer to the controller's documentation.
1 Press the MENU button so many times until Addr is indicated in the display. Confirm with the ENTER
button.
2 The display indicates 2CH (2 DMX channels), 3CH (3 DMX channels), 4CH (4 DMX channels) or 6CH (6
DMX channels). Use the buttons UP and DOWN to select the desired number of DMX channels. Confirm
with the ENTER button.
3 Now the display indicates the menu item for the DMX start address d***. Use the buttons UP and DOWN
to set the address. Confirm with the ENTER button.
4 A dot will flash when DMX signals are being received. If no control signals are available, the display will
flash.
Note: Please make sure that you do not have any overlapping channels in order to control each device
correctly and independently from any other fixture on the DMX chain. If several devices are addressed
similarly, they will work synchronically.
Functions in DMX mode
2-channel mode
Channel Value
000 – 255 Warm white 0-100%
1
000 – 255 Cold white 0-100%
2
3-channel mode
Channel Value
1
000 – 255 Total brightness 0-100%
Master dimmer
000 – 009 No function
2
Strobe effect 010 – 255 Strobe effect with increasing speed, 0-100%
000 – 009 LEDs off
010 – 029 2400K
3
030 – 049 2700K
Color
050 – 069 3200K
temperature
070 – 089 4300K
090 – 255 5000K
Function
Function
28/32 00131545, Version 1.0