Cleaning And Maintenance; Replacing The Fuse - EuroLite LED CBB-2 Bedienungsanleitung

4-channel mode
Channel Value
1 000 – 255 Warm white 0-100%
2 000 – 255 Cold white 0-100%
3
000 – 255 Total brightness 0-100%
Master dimmer
000 – 009 No function
4
Strobe effect
010 – 255 Strobe effect with increasing speed, 0-100%
6-channel mode
Channel Value
1
000 – 255 Total brightness 0-100%
Master dimmer
000 – 009 No function
2
Strobe effect 010 – 255 Strobe effect with increasing speed, 0-100%
000 – 255 Warm white 0-100%
3
4 000 – 255 Cold white 0-100%
000 – 009 No function
010 – 049 Auto program 1, with increasing speed
050 – 089 Auto program 2, with increasing speed
5
090 – 129 Auto program 3, with increasing speed
Internal
programs
130 – 169 Sound program 1, with increasing speed
170 – 209 Sound program 2, with increasing speed
210 – 255 Sound program 3, with increasing speed
000 – 009 LEDs off
010 – 029 2400K
6
030 – 049 2700K
Color
050 – 069 3200K
temperature
070 – 089 4300K
090 – 255 5000K

CLEANING AND MAINTENANCE

The outside of the device should be cleaned periodically to remove contaminants such as dust etc. The
lenses, in particular, should be clean to ensure that light will be emitted at maximum brightness.
1 Disconnect the device from power and allow it to cool before cleaning.
2 Clean the surface with a soft lint-free and moistened cloth. Never use alcohol or solvents as these may
damage the surface. Make sure that no liquids can enter the device.
3 The device must be dry before reapplying power.
There are no serviceable parts inside. Do not open the housing. Do not try to repair the device by yourself as
this may result in damage. Maintenance and service operations are only to be carried out by authorized
dealers. Should you need any spare parts, please use genuine parts. Should you have further questions,
please contact your dealer.

Replacing the fuse

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
1 Disconnect the device from power and allow it to cool.
2 Open the fuse holder of the mains connection with a fitting screwdriver.
3 Remove the old fuse from the fuse holder and replace it with a new fuse.
4 Carefully push the fuse holder back into its position before reapplying power.
Function
Function
29/32 00131545, Version 1.0