Care And Maintenance - Axkid SPINKID Bedienungsanleitung

Care and maintenance

The seat textile cover can be machine washed at 30º C on a gentle cycle. Do not put the cover in a dryer as this can damage the cover
and the padding may separate from the fabric. Visit www.axkid.com to find videos explaining how to remove and attach the cover.
Remove the textile cover:
•
Loosen the harness by pressing the harness release button (K) and pull out both shoulder straps (F) at the same time.
•
Carefully pull the cover off from the headrest (C).
•
Lower the headrest (C) to the lowest position.
•
Unlock the harness buckle by pressing the buckle release button (G) and remove the buckle cover.
•
Undo the four buttons at the backrest on the inside of the car seat and gently remove the textile cover from the car seat. Be careful around
plastic covers not to damage the textile. Don't pull to hard.
•
Open the shoulder pads (E) and gently remove them from the Velcro.
Install the textile cover
•
Reverse the steps from the instruction above to install the textile cover on the car seat again.
•
Note that the shoulder pads can be installed at different positions. Install them in a position suitable for your child, the shoulder pads should
be positioned on top of the shoulder and on the chest of your child. Also make sure that the rubber side of the shoulder pad is facing your
child' s chest.
I
f the textile seat cover needs replacing, ensure only original products from Axkid are used. If other products are used, the Axkid car seat' s safety
system may be compromised and could lead to severe injury in case of an accident.
Any plastic parts of the Axkid car seat can be cleaned with mild detergent and water. Do not use aggressive chemicals containing solvents or
similar, as this can cause damage to the plastic and compromise the safety of the car seat.
Recycling your car seat
Axkid strongly recommends recycling of old car seats. Before leaving the seat at your local recycling station cut off the harness
straps from the seat, remove the textile cover, remove as many Styrofoam parts as possible, separate metal and plastic parts
if possible. The main part of the seat should be marked unsafe or expired (use a marker) to deter anyone from using it again.
Please check your local municipal guidelines for recycling instructions for the different materials.
18