Installation - Pkm GS 212.4 A++ NF Bedienungsanleitung

1. Unpack the appliance carefully. Dispose of the packaging as described in
chapter waste management.
2. Completely remove the transport-protection. Be very careful and do not use
any aggressive or abrasive detergents to remove residuals of the transport-
protection.
3. Install the appliance in a suitable position with an adequate distance from
sources of heat and cold.
4. Check that the appliance and the power cord are not damaged.
5. Install the appliance in a dry and well-ventilated place.
6. Protect the appliance from direct sunlight.
7. Do not install the appliance in a place where it may come in contact with
water/rain; otherwise the insulation of the electrical system will be damaged.
8. The doors must open completely and without hindrance.
9. Install the appliance on a level, dry and solid floor. Check the correct
installation with a bubble level.
10. Connect the appliance to the mains properly.
11. The nameplate is situated inside the appliance or at the back.
WARNING Disconnect the appliance from the mains (pull out the plug),
before you change the hinge position.
CAUTION! The change of the hinge position must be carried out by at least
two persons; otherwise you may hurt yourself or damage the appliance.

5. INSTALLATION

Unpacking and Positioning
Change of the hinge position
Tools required
29