Measuring Operation Sat Finder - VOLTCRAFT ST-100 Bedienungsanleitung

10. MEASURING OPERATION SAT FINDER

To test satellite reception, a sat receiver is required as voltage source and an
additional Sat connection cable with F-plugs is needed.
Observe the safety provisions when working in dangerous heights. Use de-
vices for person protection if required.
Also observe individual operating instructions of the satellite receiver system.
The multimeter comprises of two independent and gal-
vanically insulated parts. The sat fi nder only requires the
illustrated operating elements.
The sat fi nder can quickly and simply set the satellite sys-
tem to the best reception level. The sat fi nder is dragged
into the reception line between satellite receiver and re-
ceiver unit (e.g. LNB) for this.
The display signals the current reception level. The higher the level, the larger the pointer de-
fl ection. At high signal levels, the input signal for fi ne adjustment may be dampened via the dial
switch "dB".
The level display is lit when there is a signal voltage (13 - 18 V/DC).
If you are using receiver units with high amplifi cation (>60 dB), you can include an
additional dampener with at least 5 dB or use a connection cable of approx. 6 m
between the reception unit and sat fi nder for better fi ne adjustment.
38