Product Description; Scope Of Delivery; Taking Into Operation - VOLTCRAFT CT-5 Bedienungsanleitung

Product description

The cable tester CT-5 is especially developed for the in place testing
of connection and network cables. For this reason the device has a
RJ 11, RJ 45, IEEE 1394 and USB jack at the front side. Additional-
ly you can test coaxial network cables by means of the BNC jack.
By means of the light display, line run through, line interruptions,
short circuit, ground connection as well as line end (Termination)
and crossed cores are shown. In the case of short connection
cables it is sometimes not necessary to disconnect the Remote Ter-
minator from the cable tester. For the testing of already Fix installed
lines or for the function test of the measuring device Via the includ-
ed testing cables you can disconnect the Remote Terminator from
the cable tester and connect it to the other end Of the testing cable.
The switching of the individual cores within the cable (scanning) is
done automatically by the push of a button and is acoustically sup-
ported by signal sounds.

Scope of delivery

- cable tester CT-5 including Remote-Terminator
- test cable RJ 11
- test cable RJ 45
- test cable BNC
- BNC-connection resistance
- 9 V block battery
- nylon protection bag
- operation manual

Taking into operation

Make sure by means of the safety instructions and the technical
data, that the cable tester CT-5 is suitable fort he planned measur-
ing tasks.
20