Residual Risks - DeWalt D51180 Originalanweisungen

● Always wear safety glasses.
● Always wear ear protection.
● Only use fasteners of the type specifi ed in the
manual.
● Do not use fasteners made of hardened steel
(e.g. masonry nails) or fasteners which are
non-magnetic.
● Do not use any stands for mounting the tool to
a support.
● Do not use the equipment as a hammer.
● Never point any operational fastener driving tool
at yourself or at any other person. Do not use
the tool in applications requiring operation close
to the body.
● While working, hold the tool in such a way that
no injuries can be caused to the head or to the
body in the event of a possible recoil due to a
disruption in the energy supply or hard areas
within the workpiece.
● Never actuate the fastener driving tool into free
space.
● Do not attempt to drive fasteners into concrete,
stone, hardwoods, knots or any material too
hard for the fasteners to penetrate.
● Consider the conditions in the work area.
Fasteners can penetrate thin workpieces or slip
off corners and edges of the workpiece, and
thus put people at risk.
● Do not drive fasteners close to the edge of the
workpiece.
● Do not drive fasteners on top of other fasteners.
● Before putting the tool down, always check that
there is no fastener present in the nail guide.
WARNING! Use of this tool can generate
and/or disburse dust, which may cause serious
and permanent respiratory or other injury. Wear
adequate personal protective equipment.

Residual Risks

• The following risks are inherent to the use of
these machines:
– Injuries caused by improper handling of the
tool.
– Loss of control due to not gripp ing tool
firmly.
– Muscle strain of arms and hands,
especially when working overhead. Always
take regular breaks when
working for long periods of time.
– Do not use the tool while you are tired
or under influence of drugs, alcohol or
medication. A moment of inattention while
operating may result in serious personal
injury.
• In spite of the application of the relevant safety
regulations and the implementation of safety
devices, certain residual risks cannot be avoided.
These are:
– Impairment of hearing. Under some
conditions and duration of use, noise from
this product may contribute to hearing
loss.
– Loss of control caused by recoil.
– Risk of injury caused by pinch points, sharp
edges and improper handling of workpiece.
– Risk of injury caused by sharp edges when
changing nails or inserting nail sticks.
– Discomfort to hand and arms. Vibration
caused by the operating action of this tool
may cause permanent injury to fingers,
hands, and arms. Use gloves to provide
extra cushion, take frequent rest periods
and limit daily time of use.
The following pictograms are shown on the tool:
Pneumatic tool with safety yoke.
Do not use the tool on a ladder.
Wear ear protection.
Wear eye protection.
Read instruction manual before use .
Recommended minimum operating
Ps Min
4.8 Bar pressure.
Recommended maximum operating
Ps Max
8.5 Bar
pressure .
Fastener diameter.
10 mm
Fastener length.
19-89mm
E N G L I S H
19