Particular Warnings - DAB MCE-30/C Installations- Und Wartungsanleitungen

1. KEY
The frontispiece shows the version of this document in the form Vn.x. This version indicates that the
document is valid for all software versions of the device n.y. For example: V3.0 is valid for all Sw: 3.y.
In this document the following symbols will be used to avoid situations of danger.
Situation of general danger. Failure to respect the instructions that follow may cause harm
to persons and property.
Situation of electric shock hazard. Failure to respect the instructions that follow may
cause a situation of grave risk for personal safety.
2. GENERAL
Read this documentation carefully before installation.
Installation, electrical connection and commissioning must be carried out by specialised personnel, in
compliance with the general and local safety regulations in force in the country in which the product is
installed. Failure to respect these instructions not only causes risk to personal safety and damage to the
equipment, but invalidates every right to assistance under guarantee.
Ensure that the product has not suffered any damage during transport or storage.
Check that the outer casing is unbroken and in excellent conditions.
2.1 Safety
Use is allowed only if the electric system is in possession of safety precautions in accordance with the
regulations in force in the country where the product is installed (for Italy CEI 64/2).
The appliance is not intended to be used by persons (including children) with reduced physical, sensory
or mental capacities, or who lack experience or knowledge, unless, through the mediation of a person
responsible for their safety, they have had the benefit of supervision or of instructions on the use of the
appliance. Children must be supervised to ensure that they do not play with the appliance.
2.2 Responsibility
The Manufacturer does not vouch for correct operation of the machine or for any damage that it may
cause if it has been tampered with, modified and/or run outside the recommended work range or in
contrast with other indications given in this manual.
2.3

Particular warnings

Always switch off the mains power supply before working on the electrical or
mechanical part of the system. Before opening the equipment, wait at least 10
minutes after disconnecting it from the power supply. The capacitor of the direct
current intermediate circuit remains charged with dangerously high voltage even
after the mains power has been turned off.
Only firmly cabled mains connections are admissible. The appliance must be earthed
(IEC 536 class 1, NEC and other applicable standards).
Mains terminals and motor terminals may still have dangerous voltage when the
motor is stopped.
ENGLISH
36