Backlight - eta Vintero Bedienungsanleitung

GB
3) FUNCTIONS
The appliance has two basic functions with various properties:
a) Cooling function
To cool down the air, press the cooling button B7. The activated function is indicated
by B10 icon. With this function, A8 pump is active, pumping the water from the tank to
the cooling pad A10. Switch off the function by pressing B7 button again (B10 icon will
disappear), and switch the appliance to a standard fan function.
b) Fan function
This is a standard ventilation function without the activated pump and with no need to have
water inside A5 tank. This is the default function when the appliance is switched on.
It is only indicated by the switched on/off icon B1, and by the respective icons of speed
and blowing mode setting.
– If you want to activate the cooling functions, water must be present in A5 tank.
Regularly monitor the water level so as it will not drop below MIN level mark.
Do not have the appliance without any water when the pump is switched on!
– If you are going not to use the appliance for a long time, we recommend activating
3 b) fan function at the high speed for at least 20 minutes before switching off.
This will completely dry the internal components of the appliance.
4) OSCILLATION
By pressing B5 button, you activate oscillation of internal blades A2. The function
is indicated by the icon B11. Outer blades A1 must be set up manually.

5) BACKLIGHT

You turn off all pilot lights by pressing B3 button. By pressing the B3 button again, you turn
on the pilot lights signalizing setting of an appliance.
6) TIMER
With B4 timer button you may set up switching the appliance off after 7.5 hours
at maximum. Each press of the button will set up the timer as follows:
0,5 H - 1H - 1,5 H - 2H - 2,5H - 3H - 3,5H - 4H - 4,5 H - 5H - 5,5 H - 6H - 6,5 H - 7H - 7,5
H - timer off - 0,5 H - 1H - 1,5 H...
– Remote control unit C may also be used to switch between modes and functions. The
appliance response is the same as when controlled by buttons on the control panel B.
– Aim the remote control unit at the front side of the control panel B.
– Proceed according to Fig. 2 to replace battery (CR2025).
– If you are not going to use the appliance for a longer period of time, take out the
batteries.
– Keep battery out of reach of children and incapacitated people. A person, who would
swallow the battery, must seek medical help immediately.
– If the battery are leaking, take them out immediately, otherwise they may damage
the appliance.
Notes and recommendations
Remote control
26 / 54