Display And Buttons; Initial Use; Removing The Air Purifier; Setting Up The Air Purifier - Beurer LR 310 Gebrauchsanweisung

Display and buttons

1
1 ON/OFF button
Switches the device on/off
2 AUTO button
Activates the automatic function (fan speed auto-
matically adapts to the ambient air quality and the
LED is lit continuously). If the light below "Replace
Filter" is flashing, change the filter. After changing
the filter, hold down the AUTO button to reset the
automatic counter for the filter change.
3 FAN SPEED button
The air purifier has three fan speeds:
(medium) and

6. Initial use

6.1 Removing the air purifier

1. Open the cardboard packaging.
2. Remove the device from the top of the box without opening the film bag.
3. Now remove all plastic films. Remove the combi filter from the device (see "Filter change" section) and
take it out of the plastic film. Then re-insert the combi filter into the device.
4. Check the device, mains plug and cable for damage.

6.2 Setting up the air purifier

1. Place the air purifier on a firm, level surface to prevent vibrations and noise.
IMPORTANT
If you wish to reposition the air purifier, only carry it by the handle on the rear of the device.
2. Set up the air purifier in such a way that provides 30 cm clearance on all sides.
3. Make sure that the air inlet and air outlet are never blocked.
2
(low),
(high).
4
3
4 UV-C light button
Switches the UV-C light on/off
5 TIMER button
The air purifier features a timer function that you
can use to determine the number of hours the
air purifier should run for before it automatically
switches itself off. The air purifier has three timer
periods: 2H (two hours), 4H (four hours) and 8H
(eight hours).
17
5