Thinning Hair; Cutting Hairlines And Beard; Cleaning And Care - Silvercrest SHBS 500 B2 Bedienungsanleitung

BB*5$B%ERRN 6HLWH  )UHLWDJ  2NWREHU    
• Hold the device in such a way that the
comb attachment|1 lies as flat as possi-
ble on the head. Move the device
through your hair smoothly and in only
one direction so as to avoid catching.
• If possible, cut against direction of hair
growth.
• In order to catch all the hair, move the
device several times through each sec-
tion of the hair.
• Comb the hair repeatedly and well.
• In order to achieve a straight cutting line
for cutting lengths over 20 mm, the de-
vice should be passed through the hair
several times from different directions.

6.3 Thinning hair

Use the thinning function to reduce the vol-
ume of the hair without changing its length.
• Push the slider|3 upwards towards the
shaving head|10. The thinning function
integrated into the shaving head|10 is
extended upwards.
6.4 Cutting hairlines and
beard
WARNING! Risk of injury!
The points of the shaving head are sharp.
Handle with care.
• Figure A: adjust the cutting lengths on
the side of the comb attachment|1, de-
pending on the desired hair length, and
read the cutting lengths on the side of
the comb attachment|1 using the mark-
ing|11. Now, shorten your beard step-
by-step.
• Use the device only with the shaving
head|10 and without comb attach-
ment|1, to cut hair very short or to cut
beard and hairline. In this way you can
cut hair lengths of 1-2 mm evenly.
8 GB

7. Cleaning and care

DANGER! Risk of electric
shock!
~ Pull the power unit|8 out of the wall
socket before you clean the device.
WARNING! Risk of injury!
~ Always switch off the device before
cleaning it.
WARNING! Risk of material dam-
age!
~ The blades|2 of the shaving head|10
may only be cleaned with medical alco-
hol. Do not use any water or other liq-
uids. Oil the blades as described in the
following chapter.
~ Do not use any astringent or abrasive
cleaning agents.
NOTE: clean and oil the device after every
use.
• Remove the comb attachment|1. Rinse
the comb attachment|1 with water and
let it dry before reattaching it to the de-
vice.
• Wipe down the housing of the device
with a damp cloth.
Cleaning and oiling the shaving
head
1. Figure B: remove the shaving
head|10 from the device by pressing it
with the thumb towards the rear.
2. Remove the hair remnants from the
shaving head|10 by using the cleaning
brush|14 included in the delivery.
3. Clean the blades|2 of the shaving
head|10 with medical alcohol (not sup-
plied). Do not use any water or other
liquids. Let the shaving head|10 dry.
4. Apply a few drops of the supplied
oil|15 to the blades|2 of the shaving
head|10 and spread it out evenly. Us-
ing a soft cloth, wipe off the surplus oil,
if necessary. Only use acid-free oil,
such as e.g. sewing machine oil.