Product Disposal; Care And Maintenance - Zelmer ZSVC822 STEFAN Benutzerhandbuch

PL EN
INSTRUCTION OF USE
Note:
Before using the Cordless Vacuum cleaner for the first time, clean it with a soft, damp cloth and dry
thoroughly.
Do not immerse the Cordless Vacuum cleaner in water or any other liquid.
Assembling the Cordless Vacuum cleaner
1. Assembling the battery pack
Fit the battery pack onto the main body base until it clicks into the position.
If need to remove the battery pack, hold the main body, press the release knob and remove the battery
pack. (FIG.1)
2. Assembling the aluminum tube
Fit the tube onto the main body's air inlet until it clicks into the position.
If need to remove the tube, hold the main body, press the release knob and remove the tube (FIG.2)
3. Assembling the electrical floor brush
Fit the electrical floor brush on the tube until it click into the position.
If need to remove the electrical floor brush, hold the aluminum tube, press the floor brush release knob and
remove the brush from the tube. (FIG. 3)
4. Assembling the accessory 2 in 1 brush
Fit the 2 in 1 brush or Flat Suction on the main body's air inlet and/or on the tube until it clicks into the
position.
The 2 in 1 brush and Flat Suction are good for cleaning stairs, in corners. (FIG. 4)
Operating the Cordless Vacuum cleaner
Before first time use, ensure the vacuum cleaner has been charged 4hours.
Turn on the Cordless vacuum cleaner by pressing the ON/OFF button.
Note: Battery indicator light represents battery capacity and will illuminate during use. The indicator light will
extinguish one at a time as the battery runs out.
Warning: Do not use the Cordless Vacuum cleaner without the removable filter or dust bin not in position.
Charging the battery
Turn off the Cordless vacuum cleaner.
Connect the adapter to the charging port on the main unit.
Plug the adapter into the main power supply
The battery indicator display will flash and illuminate one by one. Once the battery fully charged, the battery
indicator display will extinguish
Warning: Do not use any mains power adaptor other than that supplied, as using an alternative will increase
the risk of injury and/or damage to main product. (FIG.5)

CARE AND MAINTENANCE

Filter replacement and cleaning (FIG.6)
1. Turn off the Cordless vacuum cleaner
12
2. Press the dust bin release knob, remove the dust bin.
3. Come up with the filter, empty the dirt inside.
4. Cleaning the filter in water, wait for it to dry completely.
5. Put the filter back into the dust bin carefully.
6. Put the dust bin back into the main body
Rotating brush cleaning (FIG.7)
1. Turn the brush bottom screw to unlock position (pictured)
2. Open the brush bottom fixed device.
3. Show brush, clean the rotating brush on the twisting thing.
4. Put the rotating brush back.
5. Turn the brush bottom screw to lock position.
BATTERY REMOVAL AND DISPOSAL
Take your cordless vacuum cleaner at the end of the long lifetime is not easy in the garbage as it fitted with
a Li-ion battery, but disposed of it in an environmentally friendly way.
Discarded batteries are environmentally friendly and disposed of it in accordance with applicable regulations.
Discharge the battery by running the appliance to stop the engine at idle. Remove the battery from the
appliance.
Dispose of the battery to a collection of chemical waste from
TROUBLESHOOTING
COMMON TROUBLE POSSIBLE CAUSES
MAIN UNIT NOT WORKING Low battery power
Suction intel blocked
WEAK SUCTION Dust bin or filters blocked with
dust
Rolling brushed is jammed
with hair or long straps

PRODUCT DISPOSAL

This product complies with European Directive 2012/19/EU on electrical and electronic devices,
known as WEEE (Waste Electrical and Electronic Equipment), provides the legal framework ap-
plicable in the European Union for the disposal and reuse of waste electronic and electrical devic-
es. Do not dispose of this product in the bin, instead going to the electrical and electronic waste
collection centre closest to your home.
The product may contain batteries. Remove them before disposing of the product and dispose in
special containers approved for this purpose.
EN
PL
SOLUTION
Charge the unit before use
Remove blockage in suction
inlet
Remove the dust inside the
bin or filters
Remove hair or long straps
from rolling brush
13