Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Attention!
Only press the lock-on button when using a stand. In case of
!
every stop of the machine, the lock-on button has to be
released immediately by pressing the on/off switch.
Consequently, you can avoid an unintentional restart of the
machine (physical hazard).
Speed Selection
The machine is equipped with a mechanical two-speed gearbox. Select the
required speed by pressing-in, shifting and engaging. The position of the
lower speed is in direction of the working spindle. Change the speed only
when the machine is not running, and support the speed-changing by
slightly rotating the work spindle.
Care and Maintenance
Before starting with the maintenance- und repair works
you have to disconnect the plug from the mains.
Repairs have to be carried out only by qualified and due to education and
experience suited personnel.
After every repair the machine has to be inspected by an electric specialist.
Due to its design, the machine needs a minimum of care and maintenance.
The following works have to be carried out regularly:
The electric tool as well as the ventilation slots always has to be
clean.
During work, please pay attention that no foreign elements get into
the interior of the machine.
In case of failure, a repair has to be carried out by an authorized
service workshop.
Raw material recycling instead of waste disposal
In order to avoid damages on transportation, the power tool has to be
delivered in sturdy packing. The packing as well as the tool and its
accessories are made of recyclable materials and can be disposed
accordingly.
The tool's plastic components are marked according to their material,
which makes it possible to remove environmental friendly and
differentiated because of available collection facilities.
Environmental Protection
16
Werbung
