Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Twist drills:
Drills with MT 2 connection can be directly fit in the drill spindle.
For twist drills with MT 1 connection use a reducing sleeve MT 2 – MT 1.
For twist drills with parallel shank use a drill chuck B18 with appropriate
taper mandrel MT 2 - B18.
Core drills:
For working with core drills you need a mount MT 2 – Ø 19 Weldon.
Fit the ejector pin of suitable length in the core drill.
Place the core drill in the Weldon mount so that the two Allen screws
hit the two surfaces of the shaft.
Tighten the Allen screws equally.
Attention!
Never press the tool into the tool connection with might and main!
Morse tapper and – cone have to be free of grease and dirt.
Removing the tool
Put the drill drift in the opening of the gearbox collar.
If you cannot insert the drill drift through the work spindle, turn the work
spindle slightly.
Remove the tool from the work spindle by a slight impact on the drill drift.
Tool Protection
Wrong handling can cause damages on the tool and injuries of the user.
Therefore, the following instructions should be observed:
Do not allow blocking of the tool.
Only use original accessories made by EIBENSTOCK.
Switching on and off
Short-Time Operation
Switching-on:
press the on/off switch
Switching-off:
release the on/off switch
Permanent Operation
Switching-on:
press the on/off switch and, keeping it pressed, engage the
lock-on button
Switching-off:
press the on/off switch and release it again
15
Werbung
